 | To handle power boats to 50 feet, sailboats to 55 feet |
| Overall length of 40 feet (longer or shorter if desired) |
| Overall bed length of 32 feet +/- |
| Overall width of 8 feet 6 inches |
| Capacity of 50,000 pounds |
| Power plant:
 | John Deere industrial diesel engine (or equivalent) with complete
instrumentation and full enclosure |
| Four two-speed hydraulic drive units with brakes at rear |
| Two hydraulic drive/steering motors at front |
| Hydraulic drive pump with hydrostatic variable displacement
transmission |
| Operator's station with joystick controls |
|
| 10" x 12" x 1/2" structural steel tube main frame, reinforced with 12"
x 25 lb. structural channel steel |
| Hydraulics:
| Six fully adjustable hydraulic arms to handle up to 8' draft;
canting forward arms; aft-facing or forward-facing rear arms |
| Hydraulic walking beam suspension to lift/lower frame each side |
| Pilot-operated double-locking valves on all cylinders |
| Solenoid-actuated remote control with pendant operation |
|
| Six high flotation/low profile heavy lug industrial yard tires |
| Four galvanized steel slide-through keel-supporting cross beams |
| Stainless steel T-pins and hardware |
| Finish: Entire unit sandblasted to white steel; professionally
finished with two coats high-build epoxy primer with hardener, three coats
high performance acrylic urethane
with hardener - choice of any color Galvanized arms, arm extensions, pad
brackets, cross beams |
| Reinforced aluminum cross beams in lieu of steel beams each |
| Stainless steel hydraulic cylinder piston rods (arms) |
| Stainless steel hose ends and fittings |
| Solid tires in lieu of pneumatic tires |
| Welded strap hangers and straps for sailboat keels |
| Submersible use: Raised operator’s station platform for above-water
operation, stainless steel piston rods, hose ends and fittings, welded
strap hangers and straps for sailboat keels, solid tires |
